14 www.millipore.com
Setting Up the System
To identify the parts of the stirred cell, refer to the
diagrams in the appropriate model parts list section.
This section explains how to install the membrane and
stirring assembly.
Membrane Installation
NOTE: Handle the membrane by its edges, to avoid
scratching or contaminating the surface.
Model 8003 only:1.
Invert the cell body and place the smaller membrane
holder O-ring (Model 8003 Parts List — N) into the
recess. Gently tap to ensure that the O-ring remains
when the body is upright. Place the membrane into
the holder, shiny side up. Then place the larger
membrane holder O-ring (Model 8003 Parts List — F)
down, so that it contacts and seats the membrane
evenly in the bottom of the holder.
All other models (8010, 8050, 8200, and 8400):
Place the membrane into the holder, shiny side up.
Place the O-ring on top of the membrane. Gently
push the O-ring down, so that it contacts and seats
the membrane evenly in the bottom of the holder.
Fit the membrane holder into the cell body, aligning 2.
the tabs on the sides of the holder with the slots in
the base of the cell body.
Invert the cell body and membrane holder; screw the 3.
base rmly into the bottom of the cell body.
Push the ltrate exit tubing onto the exit spout of the 4.
membrane holder.
99228_RevM.indd 14 8/7/2008 3:10:17 PM
To Next Page
Loading...
