56
15 Spindle override and direction: The position of the spindle override and the
resulting rpm (if there is no spindle encoder) or the actual rpm (if there is a
spindle encoder). This line also displays whether the spindle is off or running CW
or CCW.
16 The spindle load meter will show the load on the spindle. It becomes longer and
changes color from blue to green to yellow to red as the load increases.
17 Coolant, Off, Mist, Flood or Mist/Flood
For complete detailed information about the 7200 control and its operation, refer
to the 7000 Series CNC Operation Manual.
To Next Page
Loading...
