Parameters P-40 through P-50 used specifically for
OCM applications. Refer to Applications.
P-40 primary measuring device
enter option: 1 = exponential ( F )
2 = Palmer-Bowlus
3 = H-flume
4 = universal head vs flow - curve *
5 = universal head vs flow - linear *
* these options are divided into 2 levels of subparameters:
H - # where: H = level coordinate
F - # F = flow coordinate
# = breakpoint 1 to 11
Access is made by scrolling through the levels.
press display will show
Setting of the subparameters is done in the same way
as with the ‘ P ’ parameters.
To exit the ‘ H ’ and ‘ F ’ subparameters
4
select any ‘ H ’ or ‘ F ’ parameter
return to ‘ P ’ parameters
ENTER
CLR
ALT
DISP
PL-443 7 – 10
To Next Page
Loading...
