Milnor 48040F7D - Safety Placards and Locations-ISO-48040 F7 B, 48040 F7 N; 48040 F7 B (Az), 48040 F7 D (Az)

PELLERIN MILNOR CORPORATION
BIIFLM03 (Published) Book specs- Dates: 20150219 / 20150305 / 20150305 Lang: ENG01 Applic: IFL
Safety Placards and Locations—ISO—48040F7B, 48040F7N,
48040F7B (AZ), 48040F7D (AZ)
Figure 1: Safety Placards and Locations—ISO—48040F7B, 48040F7N, 48040F7B(AZ), 48040F7D(AZ)
General Views
Legend
A. Rear view
B. Left side view
C. Front view
D. Right side view
.
• This document is for placards that agree with:ISO
• If the placard is removed or you cannot read it, replace the placard immediately.
• If the placard is aluminum, the mounting holes are on the machine. Use #8 self-tapping
screws. If the placard is vinyl, put the placard in the approximate location shown.
23