MIMAKI CF-1215 User Manual

— 1.29 —
Setting for automatic head retract [AUTO VIEW]
A period of time required to cause the head to start to travel to its retracted position after the completion
of cutting (plotting).
If the blower is powered on, it switches off after the head has automatically retracted.
Set values
OFF: Automatic head retract is not performed.
1s: When one second has passed after the completion of cutting (plotting), the head starts
to travel to the retracted position
3s: When three second has passed after the completion of cutting (plotting), the head starts
to travel to the retracted position
1Press the
PAGE
+
key several times
until the LCD indicates page 3 of the
LOCAL MENU.
2 Select the [MODE SET].
3Press the
PAGE
+
key until the LCD in-
dicates page 2 of the [MODE SET].
4 Set the [AUTO VIEW] to one of the
following.
OFF, 1s, 3s
Retracted position
[ LOCAL ] 1 / 4
TOOL SELECT ———>
CONDITION ———>
TEST CUT ———>
[ LOCAL ] 3 / 4
INTERFACE ———>
MODE SET ———>
SELF TEST ———>
< MODE SET > 1 / 5
Z STROKE ∗7 mm >
MULTI–PASS ———>
VACUUM ∗AutoOFF>
< MODE SET > 2 / 5
AUTO VIEW ∗OFF >
DUMMY CUT ∗ON >
ONE STROKE ∗OFF >
F1
+
F2
+
PAGE
+
PAGE
+

MIMAKI CF-1215 Specifications

General

Brand	MIMAKI
Model	CF-1215
Category	Plotter
Language	English