MIMAKI CG-60SR - How to Place the Roll Sheet

2-18
How to Place the Roll Sheet
If you want to use the roll sheet, you must mount the roll-placing table.
1
Raise the clamp lever.
2
Lay down the roll-placing table, fitting
to the width of the roll sheet.
• As the roll-placing table has a magnet, just attach
it to the device and it is fixed.
• Fix the roll-placing table 2 to 3mm away from the
sheet width. Pressing the both ends hard may
cause the roll not to be rotated, resulting in no
sheet feeding.
3
Lay up the roll sheet on the roll-placing
table.
• Be careful about the sheet direction.
4
Lock the stopper of the roll-placing
table.
• The stopper prevents the sheet from rotating
when it is pulled out.
• Setting the stopper helps to easily maintain the
sheet in the Step 5.
To slightly hit.
O K N G
Locked as tilted
to the main unit.
Locked as tilted
to the main unit.