© 2014 MIMAKI ENGINEERING CO.,LTD. 2.1.2 P.2
2.1.2 Maintenance Precaution
1
2
3
4
Precautions in Work
Take the following precautions during maintenance work:
1. Provide adequate space for the maintenance work.
2. When performing tests with the electrical box cover open, be careful not to receive an electric shock from any live
part. Also take care not to drop screws or any other parts into the circuit box.
3. Take care to avoid insufficient insertion or skewed insertion of any connector or FFC.
4. Do not touch FFCs with your fingers. Doing so may cause contact failure.
5. The lever of each FFC connector breaks easily. Move it up or down gently when releasing or locking the connector.
6. Pay attention to the movement of the head if you are required to perform maintenance work with the power on. (Keep
all parts of your body away from moving parts.)
7. Use jog keys to move the media (in the X direction) or the head (in the Y direction).
The media or head can be moved by hand with the power turned off. In doing so, however, exercise care to move
them slowly.
8. Do not tilt the machine if ink cartridges are filled with ink. Doing so can cause ink leakage.
Follow the procedure described below before transporting the machine. Use the dedicated packaging materials to
transport the machine.
Remove the ink from the tubes by following the procedure of [#ADJUST] -> [HEAD WASH].
Remove the maintenance solution from the tubes by following the procedure of [#ADJUST] -> [MaintWashLiq-
uid].
Remove the waste ink tank.
Install the head stopper to fasten the head.
R.1.0
Service Documents > Service Outline > Safety Precaution > Maintenance Precaution
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver
Remark
1.0
To Next Page
Loading...
