MIMAKI CJV150 series - Specifications for Ink

© 2014 MIMAKI ENGINEERING CO.,LTD. 3.1.4 P.1
1
2
3
4
Service Documents > Basic Specification > Main Unit Specification > Specifications for Ink
Model CJV150/300 Issued 2014.09.15 Revised F/W ver Remark
1.0
Rev.
R.1.0
3.1.4 Specifications for Ink
 Specifications
No. Item
Specification
SS21 (Solvent ink) Sb53 (Aqueous sublimation transfer ink)
1 Supported model Std model
Std model
*1
, aq model
2 Supply Dedicated ink cartridge
3 Ink color • Black (K)
• Cyan (C)
•Magenta (M)
•Yellow (Y)
• Light cyan (Lc)
• Light magenta (Lm)
• Orange (Or)
• Light black (Lk)
• White (W)
• Silver (Si)
•Black (K)
•Blue (Bl)
• Magenta (M)
•Yellow (Y)
• Light blue (Lbl)
• Light magenta (Lm)
• Dark black (DK)
4 Ink capacity 220/440cc cartridge 440cc cartridge
5 Available period The period is printed on the ink cartridge.
6 Storage
temperature
Storage 10 to 35  C (Daily mean temperature)
* Keep the package sealed.
* Keep the package in the dark cold place where is dried and well-ventilated.
Transportation 0 to 40
 C
* Avoid passing a place where temperature is lower than 0  C or higher than 40  C.
*1.Available by a parameter change. But it does not support CJV150-75.
 The warranty is not applicable if any of the ink cartridges was disassembled or refilled with ink. Do
not use any ink cartridge disassembled once or refilled.
 The ink may freeze when it is left for a long time in a cold environment.
• For the water-based ink, if the ink has frozen, it cannot be used any more by changing in quality. Be sure to
keep the ink cartridge in the condition that the ink does not freeze.