© 2014 MIMAKI ENGINEERING CO.,LTD.
3.1.3 P.2
3.1.3 Specifications for Cutting Section
1
2
3
4
Conditions for ensuring the repetition accuracy
Item Conditions
Plotter condition Clamp pressure: High
Media setting • Side margin of the media: 20 mm or more
• Front end of the media: No warp or rising
• No separation of the media from the base paper (no air bubbles between them), which can be
caused by bending of the media
• The media must be loaded properly using the media feed function.
• The roll media must be free from loose rolling. (The right and left end faces must be flat.)
Cutting speed • 30 cm/s or less (when the supplied cutter is used)
Cutting data • Test pattern for maintenance (Successive 10 round trips in the longitudinal direction)
• No separation of the media from the base paper (no air bubbles between them) during cutting,
which can be caused by bending of the media
R.1.0
Service Documents > Basic Specification > Main Unit Specification > Specifications for Cutting Section
Model
CJV150/300
Issued
2014.09.15
Revised
F/W ver Remark
1.0
To Next Page
Loading...
