MIMAKI CJV150 series - Checking

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2.5 P.1
1
2
3
4
R.1.0
4.2.5 Checking
 Outline
For the various sensors, fans, motors, etc., this section shows the work items for checking the use to date and
inspections.
 Checking items
No. Item Description
1 Sensor test Perform all items defined in Sensor Check and make sure that there is no problem.
2 Operating test Perform all items defined in Operating Test and make sure that there is no problem.
3 Linear encoder test Perform linear encoder test and make sure that there is no problem.
4 Checking the REPLACE
COUNTER
Check the REPLACE COUNTER and note down the following records.
a. Hours of machine use
b. Drawing area
c. Drawing length
d. Scan count
5 Upload of parameters Once adjusted values or settings are changed, upload the parameters again.
6 Checking online drawing Finally, perform test drawing and online drawing and make sure that there is no problem.
Service Documents > Technical Information > Regular Maintenance > Checking
Model CJV150/300 Issued 2014.09.15 Revised F/W ver Remark
1.0
Rev.