MIMAKI CJV150 series - Required Tools for Maintenance

© 2014 MIMAKI ENGINEERING CO.,LTD. 2.2.1 P.1
1
2
3
4
R.1.0
2.2.1 Tools
 Tools
The table below shows the tools to be used in maintenance work. In the table, each adjustment item for parts requir-
ing the relevant tool is marked with “
”.
Name Category Remarks
Cover Assy Leg Assy Frame Assy Clamp Assy X-drive Assy Y-d r i v e A s sy Bear Assy SL2H PCB Station Assy Cap Base Assy Wiper Assy Waste Ink Tank Assy Print Head Unit Cutter Head Unit Electrical Device Assy Platen Assy Cartridge Assy Washing Cartridge Take-up Device Assy Roll Assy Dry & Exhaust Assy Installation or change of location Adjustment of the print head Adjustment of the pen stroke. Adjustment of the pen pressure Adjustment of the mark Adjustment of the edge Distance accuracy
Phillips Screwdriver Type 1 Tool For M2

Phillips Screwdriver Type 2 Tool For M3 to M5
(L=260 or more)
                       
For M3 to M5

Slotted Screwdriver Tool Long side 2.5mm
    
Hexagon Wrench Tool 1.5mm for M3 SSWP
 
2.0mm for M4 SSWP

2.5mm for M3 cap bolts

3.0mm for M4 cap bolts
  
4.0mm for M5 cap bolts

5.0mm for M6 cap bolts
6.0mm for M8 cap bolts

Spanner Tool Width across flats: 5mm
Width across flats:
5.5mm M3
Width across flats:
7mm M4
 
Width across flats:
10mm

Snap Ring Plier Tool
 
Loupe Tool x50 or x60

Ink Line Airtight Tester Jig OPT-J0094

Head Inside Washing Jig Set Jig OPT-J0136

Auto Cutter Height
Adjustment Jig
Jig
Head Height Adjustment Jig Jig
Bar Type Tension Gauge Tool 100gf and 500gf
 
Scale Tool 150mm

500mm

Trimmer Adjustment
Screwdriver
Tool

Long-nose Pliers Tool
  
Nippers Tool

Thickness Gauge Tool
 
Solvent Washing Liquid Expendable For cleaning or head
washing
Grease Expendable MG-A1-GU
 
LONGTERM-W2-GU

Cleaning Liquid for Water
Based Ink
Expendable
Adhesive Agent Expendable Instantaneous adhesive

Waste Cloth Expendable For cleaning
Cotton Swab Expendable
Gloves Expendable Gloves with oilproof
and tolerance
Industrial Alcohol Expendable For degreasing and
washing
Cable Tie Expendable L=150 or less
(UL-approved product)
Acetate Fabric Tape Expendable

Drafting Tape Expendable
Double-stick Tape Expendable

Tweezers Tool
Cutter Knife Tool
Tester Tool
Goggles Tool
Service Documents > Service Outline > Required Tool > Tools
Model CJV150/300 Issued 2014.09.15 Revised F/W ver Remark
1.0
Rev.