MIMAKI CJV150 series - Parameter Function

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.1.4 P.1
1
2
3
4
R.1.0
4.1.4 Parameter Function
 Outline
With the PARAMETER function, you can check and set parameters on the machine. (Available in service mode)
 Parameter function items
Be sure to upload parameters before changing them.
There is a possibility that input errors may make recovery impossible.
No. Item Description Change
1 SYSTEM PARAMETER A group of parameters as a storage of adjusted values for each machine
(printing)
Partially
permitted
2 MAINTENANCE PARAMETER A group of parameters for firmware debugging and assessment in the
development stage
Partially
permitted
3 SERVO PARAMETER A group of parameters for XY motor control. Disap-
prove
*1
*1.Do not change the disapprove parameter without instructions from developer.
4 FEED PARAMETER A group of parameters for feed control. Disap-
prove
5 HEAD PARAMETER A group of parameters to save the dot position correction and the head
voltage (correction value)
Permitted
6 OPE PARAMETER A group of parameters for operation control. Disap-
prove
7 INK PARAMETER1 A group of parameters as a storage of the operation status of the
machine
Partially
permitted
8 INK PARAMETER2 Parameters for control of function related to ink system. Disap-
prove
9 DEBUG PARAMETER Parameters for evaluation of debug in development Disap-
prove
10 SCAN PARAMETER A group of parameters for scan control. Disap-
prove
11 NOZZLE RECOVERY PARAM-
ETER
Parameters to save nozzle numbers registered at nozzle recovery Disap-
prove
Service Documents > Technical Information > Basic Information > Parameter Function
Model CJV150/300 Issued 2014.09.15 Revised F/W ver 1.10 Remark
1.0
Rev.