MIMAKI CJV150 series - Page 45

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.1.5 P.2
4.1.5 Important Parameter
1
2
3
4
31 CUT.OVR 200
Cutting overrun distance (Right)
(Cut offset from the rightmost pinch roller)
0.1mm -1000 to 500
36 WinAJST 0 Take-up motor running time adjustment in cutting mode s -10 to 60
37 CLKAJST 0 Adjusted value for lock position of cutting head clamp (fine adjustment) 0.1mm -100 to 100
40 TPlimtX 5000 X-axis limit length at registration mark detection (12,000 mm max.) mm 1000 to 12000
53 HOME X 0 Front end non-printing area adjustment -50 to 50
54 CUT ADJ 10 Automatic cut position correction -50 to 50
No. Display
Initial
Va lu e
Adjusted
Va lu e
Description Unit Input Range
R.1.0
Service Documents > Technical Information > Basic Information > Important Parameter
Model CJV150/300 Issued 2014.09.15 Revised F/W ver 1.10 Remark
1.0
Rev.