17
4
Use a cloth to wipe off the ink around the waste ink tray.
• Clean the gray area shown in the figure below.
• If the ink is stuck to the surface and cannot be wiped, use a spatula or another similar tool to
scrape it off.
5
Wipe off any ink on the flushing unit or the shutter.
• Wipe off the ink using a clean stick soaked in washing liquid. Wipe it off properly so that there is no
residual washing liquid.
Flushing filter
Shutter
Flushing unit
• If the surface of the flushing filter has become fluff, wipe it using a clean stick soaked in washing
liquid.
• If the dirt is severe or hardened, replace the flushing filter. Flushing Filter
6
Once the cleaning is complete, press the [ENTER] key.
• After the initial operation, the display returns to Step 1.
Maintenance Every One or Two Weeks
Replacing Carriage Filters
Replace the filters once every 1 or 2 weeks.
To Next Page
Loading...
