23
3
Remove the wiper
• Pull out the wiper by holding the protrusions at both the ends.
4
Insert a new wiper
• Insert the wiper by holding the protrusions at both the ends.
5
Press the [ENTER] key.
• After its initial operation, the machine returns to LOCAL.
*Being Initialized*
PLEASE WAIT
Maintenance as Necessary
Cleaning LED UV Unit
Periodically clean the ink and dust stuck on the LED UV.
• Be careful not to damage the irradiation part on the bottom of the unit when cleaning the LED UV. If the dirt
or shading on the irradiation part exceeds a certain limit, it may cause binding due to poor curing of the ink.
Ionizer Maintenance
Follow the instruction manual when performing ionizer (option) maintenance.
Storing Media
Store the media in a dust-proof place with no direct sunlight. Also, avoid storing the media in hot or highly
humid places.
To Next Page
Loading...
