MIMAKI JFX200-2513EX - Replacing the Wiper; Replace Wiper

22
4
Fill the mixed water solution until the buzzer sound stops.
• Fill the mixed water solution through the water inlet using a syringe.
• Fill an additional 100 CC after the buzzer stops.
• The mixed water solution will leak from the tank if you inject it too much.
5
Close the water inlet and air purge, and attach the cover of the left rear side of Y-bar.
Replacing the wiper
The wiper is a consumable good. If the message on the right is displayed, replace the wiper as soon as
possible.
Also, wipe the ink sticking to the lower surface of the slider.
<LOCAL>
[MNT]
REPLACE WIPER
• Cleaning wipers are sold separately. Purchase one from your local distributor or our sales office.
1
When the message is displayed, press the [ENTER] key.
REPLACE WIPER
[ENT]
EXECUTE
2
Press the [ENTER] key.
• Carriage moves onto the table.
REPLACE WIPER
[ENT]
COMPLETED
• [COMPLETED :ENT] is displayed on the screen until the replacement work is completed.
Press the [ENTER] key after the work up to Step 4 is complete.