4. Consumable Item Replacement
22
Cap Replacement
If print defects (e.g., nozzle clogging, deflection) remain unresolved even after cleaning, replace with a new
cap.
• Be sure to replace the cap if you observe any scratches or other damage on the rim.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End ], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4
Remove the cap.
• Squeeze the lugs on either side of the cap and pull off.
5
Apply maintenance liquid.
• Use a syringe to apply two or three drops of maintenance liquid to the hole at the front.
To Next Page
Loading...
