MIMAKI JV150-160 - Page 4

iii
About NOZZLE CHECK MENU ................................................. 3-23
INFORMATION MENU table........................................................... 3-23
Printing Check Flow ........................................................................ 3-24
Printing Operations at “Nozzle Missing” Judgment and Error
Occurrence...................................................................................... 3-24
Setting the Printing Check............................................................... 3-25
Setting the NOZZLE RECOVERY................................................... 3-25
Setting the Judgement Condition .................................................... 3-25
About INFORMATION MENU ....................................................3-26
INFORMATION MENU table........................................................... 3-27
Displaying the Information............................................................... 3-27
Chapter 4 Maintenance
Maintenance ................................................................................ 4-2
Precautions for Maintenance............................................................. 4-2
About Cleaning Solution ....................................................................4-2
Cleaning the Exterior Surfaces.......................................................... 4-2
Cleaning the Platen........................................................................... 4-2
Cleaning the Media Sensor............................................................... 4-3
Cleaning the Media Press ................................................................. 4-3
About MAINTENANCE MENU ..................................................... 4-4
MAINTENANCE MENUs at-a-glance................................................ 4-5
Maintaining the Capping Station .................................................. 4-6
Cleaning the Wiper and Cap ............................................................. 4-6
Washing the Head Nozzle................................................................. 4-7
Washing the Ink Discharge Passage ................................................ 4-8
When the Machine Is Not Used for a Long Time .............................. 4-9
Cleaning the Ink Head and the Area around It ..........................4-11
Nozzle Recovery Function ..................................................................... 4-12
Reset the set value.......................................................................... 4-13
Automatic Maintenance Function .............................................. 4-13
Setting the Refreshing Intervals ...................................................... 4-13
Setting the Tube Wash Intervals ..................................................... 4-13
Setting the Cleaning Intervals and Type ......................................... 4-14
Fill up Ink ................................................................................... 4-14
Replacing consumables ............................................................. 4-15
Replacing the wiper......................................................................... 4-15
If a Waste Ink Tank Confirmation Message Appears...................... 4-15
Replacing the waste ink tank before the waste ink tank
confirmation message is displayed ................................................. 4-17
Replacing the Cutter Blade ............................................................. 4-17