MIMAKI JV150-160 - Page 3

ii
Preparing for the Heaters ............................................................2-10
Changing the Temperature Settings for the Heaters....................... 2-10
Test Printing ...............................................................................2-10
Test Printing .................................................................................... 2-11
Perform test printing with the normal test pattern............................ 2-11
Perform test printing with the test pattern for checking white ink .... 2-11
Head Cleaning ...........................................................................2-12
About head cleaning........................................................................ 2-12
Perform head cleaning depending on the test printing result .......... 2-12
Setting of Media Correction ........................................................2-13
Setting of Media Correction............................................................ 2-13
If the Positions of Dots Shift... ....................................................2-13
Printing Data ..............................................................................2-14
Starting a Printing Operation ........................................................... 2-14
Stopping a Printing Operation ......................................................... 2-14
Deleting Received Data (Data Clear) .............................................. 2-14
Cutting a media ............................................................................... 2-14
Chapter 3 Setup
About SETUP MENU ...................................................................3-2
SETUP MENU table .......................................................................... 3-3
Register the optimal print conditions to match the use...................... 3-4
Setting of Media Correction............................................................... 3-5
If the Positions of Dots Shift... ........................................................... 3-6
Setting the HEATER.......................................................................... 3-6
Setting of Logical Seek...................................................................... 3-7
Setting of Drying Time....................................................................... 3-7
Setting of Left and Right Margins ..................................................... 3-8
Setting of VacuumFan....................................................................... 3-8
Setting of Feed Speed....................................................................... 3-8
Setting Auto Cleaning........................................................................ 3-9
Setting Interval wiping ....................................................................... 3-9
About MACHINE SETUP MENU ................................................3-10
MACHINE SETUP MENU table ...................................................... 3-11
Setting a AUTO Power-off............................................................... 3-12
Setting Take-up unit ........................................................................ 3-12
Setting the Display of Media Residual............................................. 3-13
When using 600 cc cartridge........................................................... 3-13
Setting a LANGUAGE ..................................................................... 3-16
Setting Time .................................................................................... 3-16
Setting Unit (Temperature/ Length)................................................. 3-16
Setting a KEY BUZZER................................................................... 3-16
Setting the CONFIRM. FEED.......................................................... 3-17
Setting the SPACE FEED MODE.................................................... 3-17
Set the network ............................................................................... 3-17
Setting event mail function .............................................................. 3-18
Initializing the Settings..................................................................... 3-22