5-3
Troubleshooting
5
Troubleshooting
Media get jammed / media is soiled
Media jamming or stained media is considered to be due to the use of an unsuitable media or improper set-
ting of media.
[HEAT] or [CONSTANT] LED does not light up
Check the basic operation.
Is a recommended media used ? Use recommended media.
Is the media not curled or bent ends ?
Avoid using any media with curls or bent
ends.
Yes
Is the media hanging down along the
platen ?
Use a take-up device or re-load the media
on the machine. (Except Type B)
( P.2-6 , P.2-13)
Is the power to the machine ON ?
Turn on the power to the machine.
(P.2-4)
Yes
Is the heater temperature setting effec-
tive ?
Set the heater temperature. ( P.3-8)
To Next Page
Loading...
