2-14
Setting leaf media
Unlike roll media, leaf media does not need to be retained with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the
platen and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
4
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
To Next Page
Loading...
