ii
Workflow ................................................................ 2-3
Turning the power ON/OFF ................................... 2-4
Turning the power ON .............................................. 2-4
Turning the power OFF ............................................ 2-5
Setting medias ....................................................... 2-6
Useable medias ........................................................ 2-6
Adjusting the head height ......................................... 2-6
Setting a roll media ................................................... 2-8
Take-up device (Except Type B) ............................ 2-13
Setting leaf media ................................................... 2-14
Changing the printing origin .................................... 2-16
Preparing Heaters ................................................ 2-18
Changing temperature settings of Heater ............... 2-18
Confirming the Heater temperature ........................ 2-19
Test printing ......................................................... 2-20
Perform test printing with the normal test pattern ... 2-21
Perform test printing with the test pattern for
checking white ink .................................................. 2-22
Check warning of white nozzle status
(Only when using SS21 white ink) .......................... 2-23
Head Cleaning ..................................................... 2-24
About head cleaning ............................................... 2-24
Perform head cleaning depending on the test
printing result .......................................................... 2-25
Perform spot color maintenance ............................. 2-25
Drawing data ........................................................ 2-30
Starting the print ..................................................... 2-30
Stopping the print temporarily ................................. 2-31
Erasing the received data (Data clear) ................... 2-31
Cutting a media ...................................................... 2-32
CHAPTER 3 Convenient use
User type ................................................................ 3-2
Registering the drawing conditions together
(Type registration) .................................................... 3-2
Registering Type ...................................................... 3-2
Setting media compensation .................................. 3-5
Setting media compensation .................................... 3-5
To Next Page
Loading...
