MIMAKI JV33-130 - Page 70

3-6
5
Press the key twice.
6
Print the compensation pattern by
pressing the key.
7
Check the compensation pattern then
input the compensative value.
Input to " + " : Move to such direction that a spacing between two lines is getting wider.
Input to " - " : Move to such direction that a spacing between two lines is getting closer.
• The band moves by approx. 0.1mm every when the compensative value is changed by
"20".
8
Press the key.
• Print and check the compensation pattern once
again.
• Compensate it according to the operations of the
step 7 if compensation is required.
9
Press the key several times to end.
[1]MEDIA COMP.
PR I NT START :
e nt
PR I NT I NG
PLEASE WA I T
[1]MEDIA COMP.
VALUE = 0
[1]MEDIA COMP.
PR I NT START :
e nt