MIMAKI JV33-130 - Page 73

3-9
Changing the set value of Heater
3
Convenient use
4
Press the key.
5
Select [HEATER] by pressing the
keys.
6
Press the key twice.
• The heater temperature setting display is dis-
played.
7
Set each heater temperature by press-
ing the keys.
Heater selecting : by the keys
Temperature setting : by the keys
8
Press the key.
9
Select [SET TIME] by pressing the
key.
10
Press the key.
11
Set it by pressing the
keys.
Item selecting : by the keys
Time setting : by the keys
12
Press the key.
13
Press the key several times to end.
• It returns to the local mode.
• Use this machine at 20-35 °C to ensure reliable printing. The heater temperatures may not rise
to the set values depending on the ambient temperature.
[1]
MED I A COMP . < e n t >
[1]
HEATER < e n t >
PRE PRT POST
2 5°C 2 5°C 3 5°C
PRE PRT POST
3 5°C 4 0°C 5 0°C
Set temperature :20 ~ 50°C
[1]HEATER
SET TEMP <en t >
[1]HEATER
SET T IME <en t >
STANDBY :OFF T IME
1 0m i n : N ONE
STANDBY :OFF T IME
1 0m i n : N ONE
Set value : NONE ,
0 to 90min (10min unit)