© 2009 MIMAKI ENGINEERING CO.,LTD.
1.2.1 P.1
1
2
3
4
5
6
7
8
R.1.0
Maintenance Manual > Operating Principle > Maintenance Function > CARRIAGE OUT
Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark
1.0
1.2.1 CARRIAGE OUT
Indication on LCD
Processing sequence
Step Processing Description
Indication
on LCD
1 Start 1. Taking the cap off
2. After moving the print head carriage to the maintenance location, the wiper
moves to the wiping location and the servo motor is turned off.
2 Maintenance 1. The unit does not operate during maintenance.
2. Waiting for the end of maintenance is displayed. It is terminated by [ENTER].
3 End 1. After the wiper moves to its origin, move the print head carriage, then perform
the initial machine operation.
See "1.1.3 Initial Machine Operation" .
Out of “Service mode”, a warning beep sounds at an interval of 30 seconds during carriage out operation to
prevent the nozzle surface and the inside of the cap from getting dry.
Display during maintenance
ST.MAINTENANCE
COMPLETED :ent
Display during initial operation
PLEASE WAIT
To Next Page
Loading...
Need help?
General