© 2009 MIMAKI ENGINEERING CO.,LTD.
FUNCTION
SETUP <ENT>
[FUNCTION],
[] / []
:TYPE.1 to 4
ENDS:HIGH [H_____H]
INNER:OFF No.6to1
ENDS:HIGH [H_____H]
INNER:OFF No.6to1
SETUP
SELECT :TYPE.1
[1]
PINCH ROLLER <ent>
[FUNCTION]: To the next screen
[FUNCTION]: To the previous screen
[FUNCTION],
[] / []
[1]MEDIA COMP.
PRINT START :ent
PRINTING
PLEASE WAIT
[1]
MEDIA COMP. <ent>
[1]MEDIA COMP.
VALUE = 0
:-255 to 255
[ENTER]: Printing
[END]: To the previous screen
[]: To the compensation screen
[FUNCTION],
[] / []
[1]DROP.POScorrect
PRINT START :ent
PRINTING
PLEASE WAIT
[1]
DROP.POScorrect<ent>
[1]DROP.POScorrect
PATTERN1 = 0.0
:-40.0 to 40.0
[ENTER]: Printing
[END]: To the previous screen
[]: To the compensation screen
* Subsequently, the input screens to
pattern 8 are displayed.
[1]HEATER
SET TEMP. <ent>
PRE PRT AFT
35
C 40
C 50
C
[1]
HEATER <ent>
[1]HEATER
SET TIME <ent>
STANDBY :OFF TIME
10min :NONE
:20 to 50
º
C
* Unit: ºC or ºF
:NONE, 0 to 90min
[FUNCTION],
[] / []
[1]PRINT MODE
DRAFT QUALITY <ent>
[1]PRINT MODE
DRAFTquality :STD.
[1]
PRINT MODE <ent>
FAST, FINE
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[1]PRINT MODE
FINE QUALITY <ent>
[1]PRINT MODE
FINE QUALITY :STD.
FAST, FINE
[FUNCTION],
[] / []
[1]PRINT MODE
SCAN DIRECITON <ent>
[1]PRINT MODE
ScanDIRECTION :Bi-D
Uni-D
[FUNCTION],
[] / []
[1]PRINT MODE
LOGICAL SEEK <ent>
[1]PRINT MODE
LOGICAL SEEK :ON
:OFF
[FUNCTION],
[] / []
[1]PRINT MODE
WhiteLayPrt. <ent>
[1]PRINT MODE
SETUP :OFF
ON (LEVEL1) to LEVEL3
[1]FINE QUALITY
PASS=
:SCAN=HiSPEED
* SS21 6+W Selection is allowed
only for filling.
[FUNCTION],
[] / []
[1]FINE QUALITY
720x540 <ent>
720x720,720x1080,
720x1440
[1]DRAFT QUALITY
PASS=
:SCAN=HiSPEED
[1]DRAFT QUALITY
540x720 <ent>
540x900,540x1080
NormSPD.
[1]INK LAYERS
SETUP :1
[1]
INK LAYERS <ent>
1 to 9
SCAN :PRINT END
0.0s : 0s
[1]
DRYING TYME <ent>
0 to 19.9s, 0 to 999s
[FUNCTION],
[] / []
[FUNCTION],
[] / []
NormSPD.
To Next Page
Loading...
Need help?
General