MIMAKI JV5 Series Maintenance Manual

© 2009 MIMAKI ENGINEERING CO.,LTD.
1.3.7 P.1
1
2
3
4
5
6
7
8
R.1.0
Maintenance Manual > Operating Principle > Ink System > Use-up Cleaning
Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark
1.0
Rev.
1.3.7 Use-up Cleaning
 As for Use-up cleaning
 This function is available only for the 4-color ink set.
 This function is intended to use the remaining ink in the cartridge where “cartridge near end” or “cartridge ink end”
occurs during cleaning with higher priority and prevent the ink of the normal cartridge from being consumed.
 When one cartridge is a normal one at the start of cleaning, ink is sucked from the cartridge with residual ink first
and then switching to the normal cartridge takes place to continue cleaning.
 When the residual ink is used up (software counter), “INK REMAIN ZERO” error is displayed, disabling the
cartridge.
Ink use-up cleaning control is only effective in NORMAL cleaning mode. It cannot be executed in any other
cleaning mode or at initial filling.

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English