User Manual minCam360compact
®
®minCam GmbH, Bundesstraße 9, 87538 Fischen, Germany info@mincam.de
Version: March 2020, according to the technical state of the art at the time of publication, subject to alterations
•
Careful handling of the system and hazard-aware operation of the system.
The manufacturer accepts no liability for any damage caused by:
•
Non-compliance with the user manual
•
Not intended use
•
Untrained personnel
•
Unauthorised conversions or technical modifications
•
Use of unauthorised spare parts.
Avoid excessive strain on the camera head and large temperature differences. The
push rod can break if it is subjected to excessive stress or if the minimum bending
radius is not reached. The push rod is subject to normal wear and tear, which,
depending on its handling, sooner or later leads to replacement of the push rod. If the
push rod is broken, do not switch the camera on again and contact Service (see 3.1.3).
1.2
Safety
1.2.1
General safety
Please use the unit only for the functions described in the instructions. Any other use
is considered to be non-intended use and may result in damage to the product or the
environment of the product.
Conversion or modification of the product impairs product safety.
The system must be visually inspected for damage and abnormalities before
each commissioning.
Checking the internal pressure of the camera and pressurizing if necessary (see
1.2.5)
The camera is battery-operated. For this purpose, it is essential to observe the
corresponding protective measures. Remove the battery from the system
during transport and when not in use.
To Next Page
Loading...