Mindray BeneVision N12 - Recording; Recorder; Starting Recordings; Manually Starting Recordings

BeneVision N Series Patient Monitor Operator’s Manual 36 - 1
36 Recording
36.1 Recorder
The thermal recorder records patient information, measurement data, and up to three waveforms.
N17/N15/N12/N12C can be configured with a built-in recorder. If the recorder is not configured, you can insert
an external recorder module into the SMR to perform recording.
N22 and N19 do not have a built-in recorder. To perform recording, insert the recorder module into the SMR.
36.2 Starting Recordings
Recordings can be started manually or automatically.
36.2.1 Manually Starting Recordings
To manually start a recording, you can either:
■ Press the hardkey on the front of the recorder.
■ Select on the current page.
36.2.2 Automatic Recordings
In the following conditions, you can set the recorder to automatically start recording:
■ At a preset interval. For more information, see 36.5Setting the Recorder.
■ When a parameter alarm is triggered. For more information, see 36.6Enabling Auto Recording on Alarm.
(1)
(2)
(5)
(4)
(3)
(1) Start/Stop key: press to start a recording or stop the current recording.
(2) Module status indicator
◆ On: when the recorder works correctly.
◆ Off: when the monitor is switched off.
◆ Flashes: if an error occurred to the recorder.
(3) Paper outlet
(4) Recorder door
(5) Latch: pull it backward to open the recorder door.