EasyManuals Logo

Mindray BeneVision N12 Operator's Manual

Mindray BeneVision N12
528 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
4 - 6 BeneVision N Series Patient Monitor Operator’s Manual
4.6 The SpO
2
Screen
For neonatal patients, if you are only concerned with the patient’s SpO
2
and pulse rate, you can use the SpO2
screen.
The SpO
2
screen displays SpO
2
related data. It also displays realtime Temp and NIBP measurements.
NOTE
• The SpO
2
screen is intended for neonatal patient only.
4.6.1 Entering the SpO
2
Screen
To enter the SpO
2
screen, choose any of the following ways:
â–  Swipe left or right on the touchscreen with two fingers to switch to the SpO
2
screen.
■ Select the Screen Setup quick key → select the Choose Screen tab → select SpO2 Screen.
■ Select the Main Menu quick key → from the Display column select Choose Screen → select SpO
2
Screen.
4.6.2 The Display of SpO
2
Screen
The following figure shows the SpO
2
screen. Your display may be configured to look slightly different.
4.6.3 Operating the SpO
2
Screen
You can access parameter setup and trends review from the SpO
2
screen. To do so, follow this procedure:
â–  Select the trend of SpO
2
, PR, or PI to enter the Tabular Trends review page.
â–  Select the SpO
2
statistics area to enter the SpO2 Statistics Setup menu. Set the range of each SpO
2
section and the target section.
â–  Select the value of SpO
2
, PR, or PI, the dashboard, or Pleth waveform to enter the SpO2 menu.
â–  Select the Temp area to enter the Tem p menu.
1
2
3
4
5
6
(1)
Tabular trend: displays trends of SpO
2
, PR, and PI.
(2) SpO
2
statistics area: displays the statistics data of each SpO
2
section.
(3)
Temp area: displays Temp measurements and alarm limits.
(4)
NIBP area: displays NIBP measurements and alarm limits.
(5)
SpO
2
area: displays measurements and alarm limits of PR, and PI. The dashboards show information of alarm
limits. The
â–³ pointers indicate the current measurement values.
(6)
The Pleth waveform
â–  Select the NIBP area to enter the NIBP menu.

Table of Contents

Other manuals for Mindray BeneVision N12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray BeneVision N12 and is the answer not in the manual?

Mindray BeneVision N12 Specifications

General IconGeneral
BrandMindray
ModelBeneVision N12
CategoryMedical Equipment
LanguageEnglish

Related product manuals