7-10 7 Service and Maitenance
3
CAUTION
The tweezers can scratch the bar. Exercise caution when
using the tweezers to clean the bar. Avoid direct contact
between the tweezers and the bar. Do not use excessive
force when cleaning the bar. Otherwise it may bend.
NOTE
Mindray recommends the acid and alkaline detergents be
used alternately for this purpose. For instance, if the acid
detergent has been used for last maintenance, the alkaline
detergent had better be used for this time.
Use tweezers to pinch acid or alkaline detergent-soaked gauze, and then
gently clean the exterior of the mixing bar until it is clean and smooth.
4
Use tweezers to pinch deionized water-soaked gauze to clean the mixing
bar.
5
After cleaning, gently pull the bar arm up and rotate the bar arm to move
the bar to a position above the wash pool.
7.3.3 Cleaning Sample/Reagent Compartment
WARNING
The probe tip is sharp and can cause puncture wounds. To prevent
injury, exercise caution when working around the probe.
BIOHAZARD
In case your skin contacts the sample, control or calibrator, follow
laboratory safety procedure and consult a doctor.
Dispose of the used gauze in accordance with your local or national
guidelines for biohazard waste disposal.
1
Place the Power to OFF.
2
Remove the cover from the sample/reagent disk.
3
Take out all calibrators, controls, samples, reagents, distilled water and
detergent from the sample/reagent disk.
4
Remove the sample/reagent disk.
5
Wash the disk with clean water and wipe it dry with clean gauze.
6
Use clean gauze (water or disinfector-dipped gauze if necessary) to
clean the inside of the compartment.
7
Load the sample/reagent disk.
8
Install the sample/reagent disk cover.
To Next Page
Loading...
