EasyManuals Logo

Mindray DP-50T User Manual

Mindray DP-50T
245 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
5-14 Image Optimization
Effects
Increasing the gain will increase the flow signal presented as well as noise,
while the signals may be missing when the gain is adjusted too low.
Steer
Description
The feature is used to adjust the ROI of color flow of different angles with
immobility of the linear probe.
Operations
Adjust through the <Steer> key on control panel or [Steer] item on image
menu.
Effects
This function is used to adjust the scan angle of linear probes, so as to change
the angle between the transmitting beam and flow direction.
Impacts
Steer is valid only for linear probes.
Scale
Description
This function is used to adjust the speed range of color flow, which is adjusted
through PRF in the system. The real-time PRF value is displayed in the image
parameter area in the upper right corner of the screen.
Operations
Press the <Scale> key on the control panel and rotate the Multifunctional Knob
on the left to adjust.
The adjusting range varies by frequency, probe and depth; adjust according to
the actual situation.
Effects
To provide a much clearer color flow image.
Use low PRF to observe low-velocity flows, and high PRF to observe high-
velocity flows.
Impacts
Aliasing may occur if low velocity scale is used and high velocities are
encountered.
Low velocities may not be identified when a high velocity scale is used.
Baseline
Description
Refers to the area where the velocity is zero in the scale. Adjust according to
the actual situation so as to get an optimum flow display.
Operations
Press the <Baseline> key on the control panel and rotate the Multifunctional
Knob on the left to adjust.
Positive value means to increase the signals above the baseline, and negative
value means to increase the signals below the baseline.
Invert
Description
To set the display mode of color flow and the color scale will be inverted when
the function is turned on.
Operations
Turn on or off the function through the [Invert] item on the image menu.
Select “Auto Invert” in the “[Setup] → [System Preset] → [Image]”, then the
color bar can automatically invert when the color flow is steered to a certain
angle to accommodate operator’s habit of distinguishing flow direction.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray DP-50T and is the answer not in the manual?

Mindray DP-50T Specifications

General IconGeneral
BrandMindray
ModelDP-50T
CategoryMedical Equipment
LanguageEnglish

Related product manuals