10
Mechanical Ventilation Mode
Make sure that the system is Standby.
Set the appropriate Plimit value in the parameter setup shortcut keys area.
Check the ACGO switch to make sure that it is OFF .
Set the bag/mechanical ventilation switch to the position.
Push the O2 fl ush button to infl ate the bag if it collapses.
Select the [Vent Mode] shortcut key to open the [Vent Mode Setup] menu.
Select ventilation mode.
1.
2.
3.
4.
5.
6.
Select the parameter setup shortcut key to set the parameters related to
mechanical ventilation mode.
Set Alarm Limits
Select the [Alarm Setup] shortcut key and then [Ventilator >>].
Set [High Limit] and [Low Limit] respectively for each parameter.
Select the [Alarm Setup] shortcut key and then [Gas Module >>].
Set [High Limit] and [Low Limit] respectively for each parameter.
1.
2.
3.
4.
Set Ventilator Parameters
Ventilation Mode
Start Mechanical Ventilation
After settings of the related parameters are already made, you can enter
mechanical ventilation mode by pushing the Standby key and then selecting
[Ok] from the pop-up menu to exit the standby status. The system will work in the
selected mechanical ventilation mode.
NOTE
:
Before starting a new mechanical ventilation mode, make sure that all related
parameters are set to the appropriate values.
To Next Page
Loading...
