Mindray WATO EX-65 Quick Guide

21
NOTE
：
No repair should ever be attempted by anyone not having experience in the
repair of devices of this nature.
Replace damaged parts with components manufactured or sold by us. Then
test the unit to make sure that it complies with the manufacturer’s published
specifi cations.
Contact us for service assistance.



Only use lubricants approved for anesthesia or O2 equipment.
Do not use lubricants that contain oil or grease. They burn or explode in high
O2 concentrations.
Obey infection control and safety procedures. Used equipment may contain
blood and body fl uids.
Movable parts and removable components may present a pinch or a crush
hazard. Use care when moving or replacing system parts and components.




WARNING
：
Maintenance
Do not use malfunctioning anesthesia machine. Have all repairs and service
done by an authorized service representative. Replacement and maintenance
of tube parts listed in this manual may be undertaken by a competent, trained
individual having experience in the repair of devices of this nature.
After repair, test the anesthesia machine to ensure that it is functioning
properly, in accordance with the specifi cations.

Mindray WATO EX-65 Specifications

General

Type	Anesthesia Machine
Model	WATO EX-65
Brand	Mindray
Tidal Volume Range	20 to 1500 mL
O2 Concentration	21% to 100%
I:E Ratio	4:1 to 1:8
Ventilation Modes	VCV, PCV, SIMV, Manual, Spontaneous
Flow Meter	O2, N2O
Vaporizer	Up to 2 vaporizers
PEEP	0 to 20 cmH2O
Gas Supply	O2, N2O, Air
Monitoring	Airway Pressure, Flow, Volume
O2 Flush	35 to 75 L/min
Respiratory Rate	4 to 100 breaths per minute
Power Supply	100 to 240 VAC, 50/60 Hz
Fresh Gas Flow	0 to 15 L/min