Softkeys (OLED)
When 3D/4D is invoked the following pre-acquisition softkeys are displayed:
Control
Description/Use
Start / Stop
Softkey Label: Start
Press to invoke the start of a 3D Volume
Pressing again during acquisition will stop it
Press the Freeze button to do the same thing
Postprocessing Mode
Softkey Label:
Render / Light / MPR /
Tomo
Use to select the type of 3D Volume desired:
Render [Surface] / Light (Surface Render with Light) / MPR / Tomo
See “Postprocessing Modes” section for details
One-up / 4-up Toggle
Softkey Label:
Press to display Volume as a single, large image
Press again to return to 4-up (A, B, C planes and Volume)
Acquisition Quality
Softkey Label: Quality
Press to select the Quality factor of the Volume set:
HIGH / BALanced / FAST
Default is HIGH
Elevation Sweep Angle
Softkey Label: Angle
Press to select the length of the Sweep: 75 / 60 / 45 / 30 / 20
Default is 60 degrees
3D/4D Mode
Press to select
Static (3D) or Real-Time (4D) mode
Once a 3D volume has been acquired the following post acquisition softkeys are displayed:
Control
Description/Use
Edit ROI
(edit box appears)
Softkey Label: Edit ROI
Only the A plane image has an adjustable curved cutline
Press to activate edit box for the selected plane
Press Set to cycle box functionality: Position / Size / Cutline
Postprocessng Mode
Softkey Label: Render / MPR / Tomo
See the pre-acquisition softkeys.
To Next Page
Loading...
