Minelab Eureka Gold User Manual

Page 12 The Minelab Eureka Gold
4.2 Installation of Alkaline Batteries
A 12 Volt battery pack to hold 8 ‘AA’ alkaline batteries is available as an
accessory item. These are useful to have as back-up if ever your NiMH
batteries are flat.
a) Ensure the detector is switched “Off” before opening the battery
compartment.
b) Slide open the lid on the battery pack.
c) Place 8 “AA” alkaline batteries (16) into the
base of the alkaline pack (15). Ensure they
are aligned as shown in figure 10 and as
indicated inside the compartment.
d) Slide the battery lid closed.
e)Place the base of the battery pack at the rear of the battery
compartment (A). Push the front edge of the battery pack firmly into
position (B). The two battery clips will “click” into position to securely
hold your battery pack in place (see figure 9).
Caution: Good quality alkaline batteries will power the Eureka for about 10
to 15 hours and should always be used instead of standard carbon
batteries. Alkaline batteries should be removed from the detector if it is to
be stored for extended periods to avoid damage caused by leaking batteries.
Using headphones will extend battery life.
Figure 10 - Replacing
the Battery Lid
16
15

Minelab Eureka Gold Specifications

General

Brand	Minelab
Model	Eureka Gold
Category	Metal Detector
Language	English