72
PG DRIVES TECHNOLOGY
7
SP1B - P
ROGRAMMING
SK73750/7
Functions indicated by (1) are only available with revisions
of controller’s identified by a letter on the barcode label
fixed to the underside of controller as shown below.
Functions indicated by (2) are not available with Egis
Controllers.
Functions indicated by (3) are only available with Egis
Controllers.
Functions indicated by (4) are only available with Egis
Controllers and SP1 programmers manufactured after
September 2002.
Resetting parameters to non-compatible values could damage
controllers and motors, and invalidate any warranties.
Contact PGDT if there is the slightest doubt.
In addition, the SP1 programmer should not be connected to
a controller when the vehicle batteries are being charged.
The high voltages present during charging may damage the
SP1 programmer.
It is possible to set up a controller so that it is unsuitable
for some uses and possibly even some vehicles. Take care
when programming a controller and if you need any advice
in programming or selecting values, please do not hesitate
to contact PGDT.
If you need any advice on programming, please do not hesitate to contact PGDT.
SOLO Type: D49594/X
17010001
MADE IN ENGLAND
A3
60
PG DRIVES
TECHNOLOGY
To Next Page
Loading...
