If the shutter speed falls below the point where the camera can be hand held safely, the camera-
shake warning will appear on the monitors. Camera shake is slight blurring caused by subtle hand
motion and is more pronounced at the telephoto setting of the lens than at the wide-angle setting.
The warning appears at approximately the reciprocal of the focal length used; if the lens is set at
100mm, the camera shake warning will appear at 1/100 second. Although the warning appears, the
shutter can still be released. If the warning appears, the following steps can be taken:
• Place the camera on a tripod.
• Use the built-in flash (p. 23).
• Increase the camera sensitivity (ISO) (p. 65).
• Zoom the lens towards the wide-angle position.
17
GETTING UP AND RUNNING
This is a quick reference guide so that the camera can be used as soon as possible.
However, it is recommended that the entire manual be read to properly operate the cam-
era and to achieve the best results.
CAMERA-SHAKE WARNING
To Next Page
Loading...
Need help?
General
