Interleaf EP5000/EP4000 DIS/REASSEMBLY, ADJUSTMENT
97.04.01
D-70
7. Touch
Menu
on the screen to show the Tech. Rep. mode menu again.
8. Touch
Level History
and enter the value for the “ATDC Ref. Level” on the Adjust Label affixed
inside the Front Door.
9. Then, press the Panel Reset Key to return the copier to the Basic screen.
1156D143CA
1156D168CA
Enter This Value on the Adjust Label.
z Should the F8 operation be run when the starter has not been replaced, check that the “ATDC Ref. Level”
value on the “Level History” screen matches that written on the Adjust Label. If they do not agree with
each other, change the “ATDC Ref. Level” value on the screen so that it matches the value on the Adjust
Label.
1156D143CA
Touch the shift key A or " to change
the value and touch Enter to validate the
new setting.
1156D169CA
To Next Page
Loading...
