Minolta EP5000 - Page 260

Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
S-36
Tech. Rep. Mode " RD Mode
Touch Panel
Display
Setting
RD Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Data Save/Load Enables transmission of Data Save and Data Load.
Data Save Transmits the command that saves the PPC RAM data to the Center.
Data Load Transmits the command that loads the data sent by Data Save back to
the PPC.
Initial Transmission Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been set
up.
Call Completion Used by the Tech. Rep. to notify the Center that his/her service job for
the copier has been completed.
Counter Clear
Used to clear the count of the spare counter set by the Center.
<Procedure>
1. Select the spare counter to be cleared.
2. Touch “Call Completion” which transmits a signal to the Center to clear
the count of the specified counter.