EasyManua.ls Logo

Minolta EP5000 - Page 78

Minolta EP5000
392 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interleaf EP5000/EP4000 GENERAL, MECHANICAL/ELECTRICAL
97.04.01
M-64
<Paper Stack Lowering/Drawer Lock>
z Paper Stack Lowering
D When the Paper Descent Key (UN5/6) is pressed or the drawer runs out of paper
during a copy cycle, the Lift-Up Motor (M13/14) is energized to turn backward.
D The rotation of the motor is transmitted via a gear train to the worm gear and Paper
Lifting Arm mounted on the same shaft, lowering them.
D When the Lower Limit Position Sensor (PC70/71) is blocked by the light blocking
plate of the worm gear, it deenergizes the Lift-Up Motor (M13/14). This completes
the paper stack lowering motion (at a paper-empty condition).
D When the Paper Descent Key (UN5/6) is pressed, the Lift-Up Motor is deenergized
when the Lower Limit Position Sensor (PC70/71) is unblocked after it has been
blocked. This unlocks the drawer. (For more details, see ”Drawer Locking Mecha-
nism” that follows.)
1st/2nd Drawer Lower Limit
Position Sensor PC70/71
Light Blocking Plate
1134M033EA
z Drawer Locking Mechanism
Drawer Guide Frame
Lock Lever
1134M034EA
D Pressing the Paper Descent Key (UN5/6) starts the
paper lowering motion.
D The worm gear is turned downward until its light
blocking plate has passed through and below the
Lower Limit Position Sensor (PC70/71), blocking
and then unblocking it. This is so the worm gear can
reach down low enough to push the Lock Lever
downward and unlock the drawer.
D When the drawer is unlocked, the Drawer Spring in
the rear of the drawer pushes the drawer out to the
front approx. 70 mm.
D Once the drawer is pushed out, the drawer Set Sen-
sor (PC61/62) is unblocked. This reverses the Lift-
up Motor (M13/14) and briefly turns the worm gear
upward until its light blocking plate reblocks the
Lower Limit Position Sensor (PC70/71), returning
the Lock Lever to the locking position.
D The Lock Lever on the bottom of the drawer con-
tacts the Drawer Guide Frame of the copier and
slides over the frame.
D The drawer is locked in the copier when the Lock Le-
ver drops into the slot in the Drawer Guide Frame.
1134M035ED
Drawer Spring
When Drawer is Slid in
When Drawer is
Unlocked

Table of Contents

Other manuals for Minolta EP5000

Related product manuals