Firstly, set the start and end position of your shooting by touching the PAN, TILT or
SLIDE circle which are in the right-side of the screen. ( You must keep touching
until the movement is complete. ) or use the "Multi Axis" button to do PAN, TILT or
SLIDE at the same time by moving your smartphone.
Secondly, Move the camera to the start position by and tap the "set start" button
at the top right-hand corner of the screen. After that move your smartphone to
assay your camera`s PAN, TILT, and SLIDE motion you want to be occurred during
shooting by Capsule 360 as described in "8.3.1 Motion Control by Smartphone".
When you complete the motion flow, tap the “set finish” button which is at the
bottom right-hand corner of the screen to save motion.
Finally, After specifying the start and end points, touch the "OK" button. When you
tap the "OK" button, you will see the motion settings which are determine by
moving smartphone in the previous screen and you can begin the shooting by
touching the "Start" button.
Set Start: When you set the starting position of your camera, tap the " Set Start"
button.
Set Finish: When you set the finishing position of your camera, tap the " Set Finish"
button.
FEATURES
9.1. Basic Timelapse
The Basic Timelapse mode offers to take time-lapse photos automatically without
changing the exposure. It has five parameters:
PAN : Set the angle of turning value by swiping your finger under the circle on the
screen. You can choose start ( S ) and finish ( F ) point by using S an F buttons.
Before you start shooting, if you want to control shooting area of your camera, you
can use the grey button inside of the PAN circle.
CCW : Counterclockwise ( Your Capsule360 will turn in counterclockwise direction.
)
CW : Clockwise ( Your Capsule360 will turn in clockwise direction. )
To Next Page
Loading...
