How does it work?
Once you start the mode, you can see the progress on the status screen. The circle
on the top will show the PAN value. After you adjust the all parameters, touch the
start button which is on the bottom right-hand corner, your camera will start
moving. When your camera starts moving, you can observe it on the app screen as
the orange area around the circle runs out. At the same time, the interval period is
over and the camera will take shots in numbers that you specified beforehand in
the settings of FPS (Frames Per Second). On the bottom right-hand corner, you will
see another shows the number of photos already taken.
Motion Settings : To turn Capsule360 to its starting point after the programmed
movements are finished, touch the “motion settings” button at the top left-hand
side of the app screen.
Smartphone Button : If you want to use your smartphone`s camera to shooting,
turn on the smartphone setting button by touching the white button which is left-
hand on the screen.
The process starts with Initial Exposure. With each frame, the exposure will be
changed towards the final exposure linearly. At the final frame, the picture will
have the final exposure. In order to be able to create custom exposure, the camera
must be in BULB mode; otherwise, all of the pictures will have the same exposure.
The exposure value can have an ascending or descending change. This depends on
the initial and final exposure values. The change of exposure will be the same
between each frame.
To Next Page
Loading...
