MIOPS Smart+ - 9.2. TIMELAPSE MODES

9.2. TIMELAPSE MODES:
In this section, you will find information about various timelapse modes.
9.2.a. Basic Timelapse:
The Basic Timelapse mode offers to take time-lapse photos automatically without
changing the exposure. It has two parameters; Interval and Frame.
Interval: This parameter defines the duration between each frame. The Interval
can have a value from 13 milliseconds up to 100 hours.
Frame: This parameter defines how many pictures are to be taken. You can set the
frame number up to 99999. If you set the frame number to 0, this will mean that
the time-lapse will continue until you stop it.
The Basic Timelapse mode does not offer any control over the exposure. The
exposure settings of your camera will be valid.
Once you start the mode, you can see the progress on the status screen. The
counter on the top will show the interval status. When the circle completes, the
interval period is over and the next picture will be taken. On the left-bottom, you
will see another counter which shows the number of pictures already taken. With
each frame, the counter will be increased by 1. Please note that, if the exposure
setting of your camera is greater than the interval value, the time lapse process
will not function properly. The exposure of your camera must be greater than the
interval value. Otherwise, the number of taken pictures will be less than shown on
the screen.