to bring the smartphone closer to the sound source.
9.3.b. Vibration:
The Vibration mode is very similar to the Sound mode. The only difference is that
vibration events are detected to trigger the camera or the flash.
Threshold: This value determines the level of the vibration that must be exceeded
to trigger. The measured vibration level will be displayed in real time with orange
bars. This will help you to understand where to set the threshold approximately to
filter out the environment vibration. You can move the threshold bar around the
button by touching the grey bar.
Delay: This parameter defines the duration between the detection of the vibration
and the triggering of the camera. You can define the delay anywhere from 0 up to
999 milliseconds.
Mode: You can select one of the two possible modes. The modes are the
“Continuous Shot” and the “Single Shot”. In the “Continuous Shot” mode, the
MIOPS Mobile will trigger the camera each time vibration is detected. This can
cause multiple pictures to be taken or multiple triggering of the flash. If you don’t
want this to happen, you can select the “Single Shot” mode. In this mode, it will
trigger the camera only once, and then it will stop. You will need to start the
vibration mode running again to take another picture.
To Next Page
Loading...