into the flash connection port. The other end of the cable is a standard PC Sync
port. This end is connected to the PC Sync port of the flash unit. If your flash does
not have a PC Sync port, you can use a hot shoe adapter with a PC Sync port
(optional accessory).
You can use both of the outputs at the same time. They are electrically isolated
from each other. They trigger the connected device synchronously. Some older
flash units require high voltages (~50 V) to be triggered. These flash units are not
compatible with the MIOPS Smart+. Using such a high voltage flash unit can damage
your device.
The camera and flash cables are designed to trigger the cameras and flash units
only. Do not use them for any other purpose. Doing so may damage the cable or the
device.
5. Mobile Application
You can use your MIOPS Smart+ as a standalone device without the involvement of
your smartphone or tablet. However, we also offer a mobile app which has been
designed as an interface to configure and control your MIOPS Smart+ easily. The
communication between the smartphone and MIOPS Smart is done over Bluetooth
connection. So, your smartphone has to be compatible with Bluetooth 4.0.
MIOPS MOBILE app is available on iOS and Android platforms. Search for MIOPS
MOBILE in your app store.
6. Connecting to MIOPS Smart+
Warning: Please make sure that your Bluetooth is turned ON in the connection
preferences of your smartphone or tablet.
After opening the mobile app, you will be asked for selecting your MIOPS product.
After selecting MIOPS Smart+ from the list, you will be listed all available Smart+
devices around. In case your device is not shown in the list, make sure that your
Smart+ is turned ON and click the Scan button again.
To Next Page
Loading...