Mircom FA-301-12LDR User Manual

82
Configuration with the CFG-300 LCD Service Tool
11.11.2 Command Menu/Dialer Config-->Telephone Line
Note: Refer to 11.2.1 Using the Keypad to Program the FA-300 on page 61 for detailed
instructions on making menu selections.
Command Menu/Dialer-Config/Telephone Line
1. Line#1 Dialing Type
[X] DTMF Dial->Default
[ ] Pulse Dial
Set the dialing type for line
#1; this is the type
recognized or preferred by
the telephone company.
Command Menu/Dialer-Config/Telephone Line
2. Line#2 Dialing Type
[X] DTMF Dial->Default
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this menu to let the
system know whether or not
to wait for a dial tone before
dialing. Cell phone setup for
the dialer requires that the
system not wait for dial tone
before dialing.
Command Menu/Dialer-Config/Telephone Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
5.Number of retries
06 ->Default
Set the number of retries for
both line#1 and line#2. This
function lets the dialer retry
on either line if it is busy or
not available. If the retry
count expires, the panel
reports a line trouble.
i
1 Line1 Dialtype
2 Line2 Dialtype
3 Line1 Dialtone
4 Line2 Dialtone
- Telephone Line -
5 Num of Retries
Line#1 Dialing Type:
[X] DTMF Dial
Line#2 Dialing Type:
[X] DTMF Dial
Line#1 Wait Dialtone
[X] ENABLE
Line#2 Wait Dialtone
[X] ENABLE
Number of Retries:
06

Mircom FA-301-12LDR Specifications

General

Brand	Mircom
Model	FA-301-12LDR
Category	Control Panel
Language	English