Using the phone system 101Final
you must have a memory key programmed as a Page key. See “Program
memory keys” on page 124.
To page all of the phones at your site, follow these steps:
1 Lift the handset
2 Select a memory key programmed with the Page feature.
3 Your phone LCD screen displays "Calling: Site Page" while the system
identifies the available phones at your site.
When the system is ready for you to begin your page, you will hear an
alert tone and the phone LCD screen displays the number of phones
being paged.
4 Speak into the handset.
To end the page, replace the handset.
A page will not be broadcast on phones that are busy.
If you select Page while there is already a page in progress, the system
will wait until the page in progress is completed before your page is
started. Your phone will display "Calling: Site Page" and you will hear
ringing while you are waiting.
Park and retrieve on the 5304 phone
Using Park and Retrieve, you can put a call on hold at a park location so that
it can be retrieved from any other phone at your business. To use this feature,
a memory key must be programmed as a Park/Retrieve key. See “Program
memory keys” on page 124.
To put a call on hold at a park location, follow these steps:
1 While on an active call, select a memory key programmed with the Park/
Retrieve feature. The system places the call on hold at a park location.
The park location is displayed on your phone LCD screen.
Calling: Site Page
Paging: 7 of 10
Parked at: 4
To Next Page
Loading...
