110 Using the phone system
Final
Follow these steps to switch a call from the conference unit to the
speakerphone:
1 If you are running the Conference Unit application, press the key labelled
Close.
2 Press the key.
3 Press the flashing Line Appearance key to take the call off hold.
Switch between handset and the conference unit on 5320/
5330/5340/5260 phones
Note that your handset must be onhook (i.e. you must be in speakerphone
mode) to use the conference unit.
Follow these steps to switch a call from the handset to the conference unit:
1 Press the key.
2 Replace the handset in the cradle.
3 Press the flashing Line Appearance key to take the call off hold and
switch to speakerphone mode.
4 Press the Conference Unit memory key to start the Conference Unit
application.
5 Press the key labelled Turn On.
Follow this step to switch a call from the conference unit to the handset:
1 Lift the handset.
Adjust volume on the conference unit on 5320/5330/5340/
5260 phones
To adjust the volume on the conference unit, follow these steps:
1 If the Conference Unit application is not currently running, press the
Conference Unit memory key to start the Conference Unit application.
2 Adjust the volume by pressing the keys labelled Volume Up and Volume
Down.
Note that the Arrow keys cannot be used to adjust the volume while using the
conference unit. These keys only apply to the handset and speakerphone
mode.
To Next Page
Loading...
