Using the phone system 77Final
3 Speak into the handset or the speakerphone.
4 To end the page, you have the following options:
• Replace the handset if using the handset.
• Select the key if using the speakerphone.
A page is not broadcast on phones that are busy.
If you select Page while there is already a page in progress, the system
waits until the page in progress is completed before your page is started.
Your phone displays "Calling: Site Page" and you hear ringing while you
are waiting.
Park and retrieve on the 5212/5312 IP phone
Using Park and Retrieve, you can put a call on hold at a park location so that
it can be retrieved from any other phone at your business. To use this feature,
a memory key must be programmed as a Park/Retrieve key.
To put a call on hold at a park location, follow these steps:
1 While on an active call, select a memory key programmed with the Park/
Retrieve feature.
The system places the call on hold at a park location. The park location is
displayed on your phone LCD screen:
You are no longer connected with the caller and your phone returns to the
idle state.
To retrieve a parked call, follow these steps:
1 From an idle phone, lift the handset.
This will select the next available Line Appearance. Select a memory key
programmed with the Park/Retrieve feature. The phone LCD screen
displays:
2 Enter the required park location using the phone keypad.
Paging: 7 of 10
Parked at: 4
Park Location:
To Next Page
Loading...
